How To Use Etekcity Digital Multimeter

Etekcity MSR-R500 DIGITAL MULTIMETER - Use Manual - Use Guide PDF.
Documents: Go to donwload!

Owner'southward transmission - (English language)

DIGITAL MULTIMETER User Manual Etekcity MSR-R500

Measurement Operation

DC Voltage Measurement

DC Voltage Ranges: 200mV, 2000mV, 20V, 200V, 500V
Input Impedance: 5Ω

Plug the ruby test lead into the VΩmA last, and then plug the black test atomic number 82 into the COM terminal.
Set the rotary switch to the appropriate measurement in Five range.
Connect the examination leads to the object of measurement. Hold them in place until the results on the display stabilize.
When measurement is completed, disconnect the test leads from the object of measurement.

NOTE

If the value of voltage is unknown, use the maximum measurement position (500V) and reduce the range until proper readings are obtained.
The LCD will brandish "1" if there in an overload within the selected range. Select a college range to obtain a correct reading.
If the circuit impedance is less than or equal to 10kΩ, the error is negligible (0.one% or less).

Air conditioning Voltage Measurement

AC Voltage Ranges: 200V, 500V
Input Impedance: 5Ω

Plug the red test lead into the VΩmA terminal, then plug the black test lead into the COM terminal.
Set the rotary switch to the appropriate measurement in V~ range.
Connect the test leads to the object of measurement. Hold them in identify until the results on the brandish stabilize. The displayed measured value is the value of sine moving ridge (mean value response).
When measurement is completed, disconnect the test leads from the object of measurement.

NOTE

If the value of voltage is unknown, use the maximum measurement position (500V) and reduce the range until proper readings are obtained.
The LCD will brandish "ane" if there in an overload within the selected range. Select a college range to obtain a correct reading.
If the circuit impedance is less than or equal to 10kΩ, the error is negligible (0.ane% or less).

DC Current Measurement

Warning:Never effort an in-circuit current measurement where the voltage between the terminals and ground is greater than 60V. If the fuse burns out during measurement, this may cause impairment to the user and/or damage to the device. Use proper terminals, functions, and range for measurement. When the testing leads are connected to the electric current terminals, do not parallel them across any circuit.

DC Current Ranges: 2000 A, 20mA, 200mA, 10A

Turn off the power to the excursion and discharge all highvoltage capacitors.
Plug the red examination lead into the VΩmA or 10A terminal, then plug the blackness test lead into the COM concluding.
Prepare the rotary switch to the appropriate measurement in A range.
Break the current path to be tested.
Connect the scarlet test lead to the most positive side of the break and the black test lead to the near negative side of the interruption.
Plow on the circuit power.
When measurement is completed, disconnect the test leads from the object of measurement.

NOTE If the value of voltage is unknown, apply the maximum measurement position (10A) and reduce the range until proper readings are obtained.

Newest Added: ESF38 INFRARED THERMOMETER 749 (NOT FOR HUMAN) INFRARED THERMOMETER 774 (NOT FOR Human being) EM-SF3 EAP1-AC

Tags: Etekcity Infrared Thermometer, Etekcity Smart Bluetooth Body Fat Scale Transmission, Etekcity Infrared Thermometer Manual, Etekcity Food Calibration Manual, Etekcity Kitchen Scale Manual, Etekcity Infrared Thermometer 774, Etekcity Digital Kitchen Calibration Manual